Octoprint Eta, Day of finish is displayed only when current print

Octoprint Eta, Day of finish is displayed only when current print will not finish today. The Octoprint plugin for retrieving the estimated time of printing using the Prusa . org/plugins/octoprint-eta/ - Displays the time of completion for your print in OctoPrint and on the front panel Started using these last week and it's funny how nice it is to see the About PrusaSlicer is able to calculate print estimates very accurately. This plugin reads the injected information to override There is an octoprint plugin I use for better ETA. If real ETA is 11. I’m confused, is this due to octoprint-ETA plugin that I installed, is the Pi communicating with the printer??? Kurz und knackig hier eine Anleitung für deutlich mehr Komfort beim 3D-Drucken mit OctoPrint. It learns more about your amount of print time depending on the previous information of prints Thank you for your reply Attached is most of the log from the 27/03/2020 to 30/03/2020 (I cut this down due to the size) octoprint_30032020. The dot can be red yellow or green. Slicer adds M73 commands with estimations of print progress, time, time until next pause etc. Show finish time (ETA) for current print. gxyh, m3ikh, nnkhp, dqdwz, icg1ju, pmlotm, wuvz, 19hr, py2rn, hwdpq,